COASTAL TECH SUPPLY
1399 S Commons Dr
Unit A3 PMB 15
Myrtle Beach, SC 29588
PHONE: 925-849-4105                     FAX: 888-889-5316
eMail: sales@coastaltechsupply.com

HOW TO FIND YOUR BROAN MODEL NUMBER

CLICK HERE IF YOU HAVE A NUTONE

Remove range hood filters by pulling down on the filter tabs. The series number is located either on the back wall of the range hood housing or on the Teflon air pan. (Example...QS1, QS2 or QS3)

Remove range hood filters. The model label is located on the underside of the canopy behind the filters.

The model label is located on the inside of left wall of the range hood canopy. Filters may need to be removed to access the label. 

The model label is located on the front of unit beneath the cook top.
Cabinet drawers or shelving may need to be removed to access label.

Remove the grille by pulling down 2 inches. Reach behind the grille and squeeze the mounting springs to remove the grille. The model label is located in the corner closest to the outlet. Some fans may have the model stamped into the motor plate instead of a printed sticker label.

Remove the grille by pulling down 2 inches. Reach behind the grille and squeeze the mounting springs to remove the grille. The model label is located on the underside of the motor plate.

Remove the glass lens which is attached by two leaf springs. Use a small flat head screwdriver to pry the glass lens from the grille. Screwdriver can be inserted into one of the small slots on the perimeter of the glass lens. To avoid scratching the surface of the grille the screwdriver can be wrapped in a thin cloth or tissue. Reach over lens and push in on springs to release. Grille is held by two screws along rim or a single nut in the center. The model label is located on the underside of the motor plate.

Remove light lens by pressing in on the sides and pulling down. Remove the light bulb. Remove the light reflector and grille by removing the center acorn nut. The model label is located on either the inside perimeter of housing or underside of motor plate.

The model label is located on the cover of the wiring box which is visible from the attic.

Removed the grille by a central knob or two screws. The model may be ceiling or wall mounted. The label is located on the inside perimeter of housing opposite wiring panel.

The model may be free standing or installed under cabinet. The label is located inside on the right wall of housing at the motor level, access through rear service panel if drawer can not be removed.

Remove the grille by unhooking the springs from the housing.  The model number can be found inside the housing on a specification label.